http://i740.photobucket.com/albums/x...9/S5030282.jpg http://i740.photobucket.com/albums/x...9/102_0667.jpg

 

theres your picture

 

How did you do that ?? Any way, so I just pulled the fuel pump fuse and had granny turn the engine over, but no spark from any? I ran the plug attached to the wire up against the power stewering pump ground wire bolt....

 

you copied the direct link ..... copy the IMG link its like the last link below your photo
let granny sleep its late lol
do you mean you used 1 plug wire and tested all plugs on same wire???

 

No. I started with #1 plug and wire, and saw no spark, so I pulled off #2 wire and plug, ran it so the electrode was touching the bolt head for the ground wire, and saw so spark either....

 

did you put fuse back in and check?

 

Yep, you gota have the fuse in for sparky. I checked #1 and #2 again, they both have the same ammount of oarnge spark. Its getting dark so I will check the voltage tomorrow

 

get a compression check done

 

Well, on my to pick up my kid the temp gauge started creeping up when ever I was at a red light. Got home shut it off for5 hours, and when I went to get burritos, I had a massive white smoke following me. So now Im going to operate on her, head gasket-water pump-timing belt-and accesory belt. My question is, I hear lots of people saynig I dont need to pull the motor, somthing about jacking the motor up and towards the passenger side ?? Any helpful suggestions ????

 

you dont have to pull motor to put new headgasket ,water pump, and timing belt
just need the right tools