power window stuck
#11
The two bolts screw into the two tabs at the bottom of the window glass. Do you have those tabs properly aligned with the corresponding slots in the window regulator?
Last edited by RonJ; 12-11-2008 at 03:28 PM.
#13
I don't understand. Can you post a photo? There's no bushing.
#15
Position the window so that the loosened bolts are inserted into the large holes of the regulator (see diagram). Next, shimmy the window to the left so that the loosened bolts slide into the smaller grooves, and then tighten the bolts in that position.
#17
This suggests that the window regulator may be bad. Remove the window again, and then the regulator. Remove the motor from the regulator. I suspect that the regulator won't move freely in a scissor-like fashion. If so, you need to replace the regulator. Look here for a replacement:
http://www.hondaautomotiveparts.com/
http://www.hondaautomotiveparts.com/
Thread
Thread Starter
Forum
Replies
Last Post
eisenberg
Mechanical Problems & Technical Chat
3
02-14-2010 07:14 PM
AGibney
General Civic Talk
0
12-29-2009 05:59 PM