Something wrong with diff?
Thread Starter
|
Junior Member
Joined: Sep 2012
Posts: 1
Something wrong with diff?
I pulled my trans apart today to replace all the bearings since the isb needed to be done....
I was checking over all the teeth...sync rows....selectectors and rings. I pulled the from the case and spin it in my hand holding onto the bearings and heard a clunk....
The diff pin looks the be moving up and down by about 1/32 - 1/16".....the drift pin is still in there good and staked.
Is this normal for a diff pin to move back and forth a little or should it be fixed in place and not move at all?
I was checking over all the teeth...sync rows....selectectors and rings. I pulled the from the case and spin it in my hand holding onto the bearings and heard a clunk....
The diff pin looks the be moving up and down by about 1/32 - 1/16".....the drift pin is still in there good and staked.
Is this normal for a diff pin to move back and forth a little or should it be fixed in place and not move at all?
Thread
Thread Starter
Forum
Replies
Last Post
MistaGlock
Mechanical Problems & Technical Chat
4
Apr 25, 2012 10:05 PM
donndiego
ECU Tuning & Fuel Management
4
Apr 1, 2007 07:24 PM
Chimera02EX
Suspension, Brakes, Tires & Wheels
12
Sep 4, 2006 10:09 PM
stylus
Suspension, Brakes, Tires & Wheels
8
Jun 11, 2006 07:46 PM
