Clutch not building pressure
#1
Clutch not building pressure
I just installed an exedy stage 1 on my 02 civic ex. everything went pretty smoothly until the pressure line broke off of the slave cylinder when I was putting the transmission back on.
After replacing the line, I attempted to bleed the clutch. After trying to bleed for about an hour, I called a friend to come take a look and he said the master cylinder was bad, so I had it replaced.
The clutch still wont build pressure, but i took the slave cylinder to auto zone and the guy up there said it was ok. Any suggestions?
After replacing the line, I attempted to bleed the clutch. After trying to bleed for about an hour, I called a friend to come take a look and he said the master cylinder was bad, so I had it replaced.
The clutch still wont build pressure, but i took the slave cylinder to auto zone and the guy up there said it was ok. Any suggestions?
#5
No brake fluid or air ever squirts out of the slave cylinder bleed hole when you push down the clutch pedal multiple times? Is the reservoir filled?
#8
bench bleed? before i connected the master cylinder to the pressure line, i pumped it until it shot fluid.. and for some reason i feel like air is coming in through the slave cylinder but there's no fluid coming out..
#9
If air is being expelled from the slave-cylinder bleed hole when the clutch pedal is pushed, then keep pumping until fluid comes out. Are you bleeding the system exactly as described in the diagram that I posted?