Ok, i have a one channel amp (600x1 @ 1 ohm) to run my two 12" subs and a 4 channel amp (55x4 @ 4 ohm) to power my 2 front and 2 rear speakers. How do i wire all this up?
thanks

 

Send it all to me, and I'll wire it up for you!

 

Wire up the subs like the diagram in the sticky at the top. Just wire each speaker to its respective terminals on the 4 channel. Other than it's the same... power, ground and remote are all shared... RCA's just go from the reciever to the amps.

 

haha yeah right. shipping would b like $92073509273 and its a b**ch to take all the seats out and door panels to get to the speakers. help????

 

Subs - wire all positive together, wire all negative together

That should be the only hard part.

 

But then I'd have a hell of a sound system, wouldn't I? lol

 

how many ohms are the subs

 

Heres everything i have right now:

"Kenwood kdc-628 headunit, 2 kenwood front components (6.5" and tweeter in the door), two 6x9" Alpine Type-R (275 watts peak) back speakers, and two 12" alpine type-s (4 ohm DVC 900 Watts peak each). Subs are in a q-logic ported box @ 1 ohm thru a hifonics brutus bx-605 mono amp. Front and rear speakers powered by a hifonics zeus zx4400 4 channel amp. Still wiring it all up right now so i hope it sounds good (my car has no rear seats, door panels, c-pillar or b-pillar panels, or anything else that i had to take out to install it all. Some kid came up to me at school today who drives an eclipse gs-t asked me if i could beat him now that i took out "all that weight". I jus laughed and drove away."