ah ok seems straght forward hehe. I will have alook tomoro.. need to pick up some fuses too.

PS. have a good time at snake pit.. not too sure what it is but saw your topic.. you seemed excited

 

snake pit is dierected electronics training branch..... they teach you how to do custom fab work that you would see in magazines....fiberglass plex etc. i'll be working on demo cars when i'm there iv' been told

 

Sounds amazing.. Ive recently got hold of all the kit to do the rear bumper camera to the screen mod from the DIY section.. cant wait to do it but still trying to find a suitable place for the 6.2" colour monitor in my 95 coupe.. Any ideas from a professional point of view?

 

either get the jdm center console and mod it ....or you can take the big center vent in the middle of the dash out and make a mold for a screen to fit in there...iv'e seen both of them done before and the look pretty tight...i'm probally gonna do the center vent mod in my wifes 93 ex

 

yeh the center vent is probably the best place.. i may try a fibre glass custom vent mold.. could you then re-direct the air pipes so it wont heat up the back of the mold? Im not too good with these things.. hehe its nice that the guys on here are so helpful.. honda revolutions forum were useless to be honest.

 

i would probally just seal it off...since theres gonna be a screen there it wont hurt anything

 

yeh your probably right.. that was my first thought i just wasnt sure if it may cause the blowers motor damage as it would be pushing against whatever i block it with.