Hi im from quebec canada and i dont speak english very well. I wonder what to do to swap d16y7 to d16z6 on my civic. The plug of the wire harness dont fix very well. On the trottle body there just 1 that fit, . I wonder if i just need to change the oval connector to the round one. I wonder what the changes i need to do. Thank you. I have a si viteck computer .

 

Welcome to the forums!

Do you have the motor in, but just not wired up? The z6 dizzy will not work with the y7 wire harness unless you re-pin the harness(es), or buy a conversion harness (OBD1 dizzy to OBD2 wire harness). Something like this:

http://www.phearable.net/shoppingcar...per-p-101.html

 

what is dizzi, and do you think that a 99 si-vteck will work on the engine with my wire harness. the plug fit to the harness.

 

Sorry, dizzy=distributor. I was lazy and didnt feel like typing it all out.

Are you asking if a b16 head from a SI will fit on your y7 block? If so, it will not work.

 

Hi I,m sorry i just forget some word. Do you think that a 99 si-vtech computer will fit with a d16z6 si-vtech engine??. Thank you very much

 

Yea, but the p28 (z6) would be better. You would need a OBD1-OBD2b ECU conversion harness.