Engine Rebuilding Question: Bearings
#1
06-08-2006, 01:47 PM
Engine Rebuilding Question: Bearings
rebuilding 1988 1.5 leter (1493 cc) honda civic engine.
Question about main crankshaft bearing.
can the main bearing be changed out without taking the engine out.
I have the 1 piece main bearing assembly out, and thus of course the bottom half of the main bearing. can the top half be tapped out (round the semi-circle and continued on) to come out ?
Question about main crankshaft bearing.
can the main bearing be changed out without taking the engine out.
I have the 1 piece main bearing assembly out, and thus of course the bottom half of the main bearing. can the top half be tapped out (round the semi-circle and continued on) to come out ?
#2
06-08-2006, 03:47 PM
RE: Engine Rebuilding Question: Bearings
Its near impossible the flywheel has to come off.It is much easier with clearence checks and torque specs with the motor out.
Thread
Thread Starter
Forum
Replies
Last Post
thakid
Engine & Internal
0
12-14-2011 01:48 PM
