repinning lock cylinder
#1
repinning lock cylinder
gents:
I need to replace the ignition lock assembly, and would like to use the same key that fits the doors, etc. The original lock cylinder was damaged by a theft attempt so is not usable. If I can get into the cylinders, I may be able to move the tumblers around from both assemblies to get the new cylinder to match the old key.
Anyone out there done this?
I need to replace the ignition lock assembly, and would like to use the same key that fits the doors, etc. The original lock cylinder was damaged by a theft attempt so is not usable. If I can get into the cylinders, I may be able to move the tumblers around from both assemblies to get the new cylinder to match the old key.
Anyone out there done this?
Thread
Thread Starter
Forum
Replies
Last Post
morgcman
Mechanical Problems & Technical Chat
1
01-30-2011 02:29 AM
outlander
Mechanical Problems & Technical Chat
1
08-13-2008 10:02 AM