talked to some guys at CornBredTuning.com on AIM last night, i think i found my tuner $150 for 3 hours of street tune, not bad (plus $40 wideband hookup, but w/e)

BUT! it is a 9 hour drive with my Civic on a trailer [&:] that'll be an adventure......

 

I'm sure you can find someone closer, there are amateur tuners all over the place who can at least get your car running so you can drive it safely to get dyno tuned.

You want me to move this into the project section?

 

yea flip theres places round here that will do it so you dont have to drive 9 hours like i was telling you last night theres one in milwaukee and one in madison that i could get you to.

 

damn, yea that cuts the trip down 4 hours, what program do they tune w/? Any links to their sites?

 

AEM EMS
-Hondata S300
-Apexi FC Commander
-Crome EFI
-Uberdata
-Accel DFI
-Haltech
thats from the one in milwaukee the have an old site but its beeyondeng.com and the one in madison is midwesthybrid.com they dont have much on their site either but i heard they do good work also

 

lol flip 9 hours from your house is to my tuner thats 1 block away... and you dont have to tow your car, go on you-tube and watch the idiots boosting with there basemaps, just dont boost and you will be fine, keep err in vacuum and just cruiiiiseee.

anyway, where are my hole dimensions? i got this adaptor plate all polished up sitting on a workplate without holes in it cuz i dont know where to put them lol.

hurry up flip

 

yeah Sov thatd be sick if you could move this to the Project section.

and Didder next time i'm home, prolly tomorow night, i'll take measurements alright? Sorry for hte wait man

 

lol, i dont care, its just gotta be drilled and i just pray thatitll fit, its really ugly, if it fits though ill be super happy, i torched in my reef sandles so i was jumping and flinching andit just wasnt good... but hey if it doesnt fit ill just go for round2!

 

If it doesn't fit, use the sledgehammer

 

Didder, got the measruemnts:

for the odd shaped plate, the center of all the holes are a 1/2" off of the corners of the plate

and for the square plate, all the holes are 3/8" off the corners of the plate

also i'm selling my RC310's for some DSM 450's. Dont totally understand the wiring/clips, so i'm gonna post a question about them.....